No Cool / No Heat Diagnostics
Our first step is isolating the fault: capacitor draw, contactor condition, thermostat signal, and refrigerant charge before any part gets replaced.
Capacitor & Contactor Replacement
Failed run capacitors and pitted contactors cause a huge share of no-start calls — we test with a microfarad meter and swap only what's out of spec.
Blower Motor & Fan Repair
Weak airflow or a burning odor at the vents often means the blower motor is drawing high amps or the bearing is failing. We test motor windings before recommending replacement.
Thermostat & Control Board Troubleshooting
Miscalibrated thermostats and control board faults can mimic a much bigger failure — we rule these out early to avoid overselling repairs.
Refrigerant Leak Detection
Using electronic leak detectors and dye tracing, we find the actual leak point rather than just topping off refrigerant, which only buys a few weeks anyway.
Ignition & Gas Valve Service
On the heating side, we test ignitor resistance, flame sensor microamp readings, and gas valve response before condemning a furnace — a dirty flame sensor is a five-minute fix, not a new furnace.
